Pace RC38, Yeti Kokopelli, Gipiemme Wheels, CNC cranks.

[ajantom]

Splitting my Yeti Kokopelli - here's the advert with lots of photos in the pre-97 section:
http://www.retrobike.co.uk/forum/viewtopic.php?p=1485500#1485500
But some of the stuff is '97 or a bit later too.

Pace RC38s - V & disc compatible, recently serviced, 1 1/8, 65mm travel. £90 posted

Yeti Kokopelli frame (1997) - Same front end as the ARC, Easton Elite/Elan stays. V/canti only. £230 posted

Chromagnon CNC'ed cranks - with red spider. 5 bolt, 94 bcd, 175mm long. £40 posted

Gipiemme MX-treme wheels - 28 spokes F&R , sealed cartridge bearings (smoother than Telly Savalas's head), Shimano 8/9 speed freewheel, rim brake only. £100 posted.

 

[Grannygrinder]

.

I'm quite interested in the cranks.
You mention one taper has widened a little.
What sort of ride was the 1 ride you went on? Was it a bimble down the shops or a few hours hard riding?
I'm just trying to get an idea of how bad the taper is.

 

[ajantom]

I'll take some better photos of them.
The ride was offroad and they didn't loosen.
Annoyingly it wasn't mentioned by the bloke I bought them off. However I don't think it was intentionally misleading on his part.
I'll take the photos and see what you think.

 

[Grannygrinder]

.

Just bought some Middleburns, sorry