CARBON TO ALUMINIUM GLUE any ideas or tips

[marin man]

I have done an experiment with a piece of carbon fibre and a piece of aluminium and used some no more nails absolutely rock solid could not get it apart just wondered if there was a more scientific method.Thanks.

 

[Andy R]

Possibly Redux 610. But what is the actual application?

Sheet to sheet, tubes into lugs ?

 

[squiffy]

3M scotch weld 9323

 

[marin man]

I think that the temperature setting issue would be difficult as I do not have an oven big enough,also needs to be slightly gap filling :? Thanks though

 

[marin man]

sheet to sheet sticking

 

[squiffy]

9323 will air cure after a few hours, is what you are bonding structual?

 

[marin man]

Not really it is supported by a hub I am going to remove a front hub from a spinergy and replace it with a rear one should be fun,The tension of the spokes holds the hub but the glue just supports the wheel in the middle I am brave and stupid but also determined

 

[squiffy]

9323 would do the job just make sure you abrade and degrease the area really well before bonding.How are you going to remove the hub? is it already bonded in?

 

[marin man]

I have two front wheels and a rear hub spare so am going to make another pair I am going to remove the front hub from one wheel and bond the rear hub in its place,the carbon is perfect absolutely mint,If I remove it very carefully I reckon it will be good to go.Where can I get the 9323 glue from :?:

 

[squiffy]

check out motorsport suppliers you can buy it in a 2 part cartridge with nozzles that mix it properly for you