Recent content by squiffy

  1. S

    Anybody got any info on this? A little new sorry.

    I might have a picture somewhere I'll have a look, I ran a hope universal adaptor on the back.
  2. S

    Anybody got any info on this? A little new sorry.

    I had an orange one of these BITD built up with boxxer 151s, hope biguns and discs MRP chain device it was a great bike but had to go to make way for my Lobo
  3. S

    Can an aluminium frame be repaired?

    Mine was just a line at the bottom of the weld, when i cleaned the paint back there was a definate crack which i drilled a hole at either end of then got the fab shop at work to tig up. I might have some spares what are you after?
  4. S

    Can an aluminium frame be repaired?

    I've got a DHi that cracked most of the way round part of the tube above the idrive, i had it welded at work 2 years ago and it's been fine since.
  5. S

    Pace RC 35's - repair loose dropout

    if using scotchweld make sure you remove all of the old glue and abrade the fork tube and especially the dropout otherwise the glue will not take properly and it will break apart.
  6. S

    Canabalism of spinergy wheel (cooked) ridden and good as new

    nice job, where did you find the glue?
  7. S

    CARBON TO ALUMINIUM GLUE any ideas or tips

    check out motorsport suppliers you can buy it in a 2 part cartridge with nozzles that mix it properly for you
  8. S

    CARBON TO ALUMINIUM GLUE any ideas or tips

    9323 would do the job just make sure you abrade and degrease the area really well before bonding.How are you going to remove the hub? is it already bonded in?
  9. S

    CARBON TO ALUMINIUM GLUE any ideas or tips

    9323 will air cure after a few hours, is what you are bonding structual?
  10. S

    CARBON TO ALUMINIUM GLUE any ideas or tips

    3M scotch weld 9323
  11. S

    New Job!! Right, now where to bike?? Oxfordy area

    Where were you looking at near Buckingham? I'm always happy to criticise other local villiages :lol:
  12. S

    New Job!! Right, now where to bike?? Oxfordy area

    I live just south of Buckingham riding wise depends what you're into theres loads of bridleways quiet roads to ride not a lot of singletrack but Woburns not a long way if you fancy some big jumps :D
  13. S

    Spooky Bandwagon

    I've got a disc mount on my metalhead i can meaure if you want
  14. S

    Old School DH

    i remember margam as it was my 1st NPS. A mile and a half tarmac hike from carpark to the bottom of the run which was about as technical as most of the run, didn't Longden and Steve Geall try to jump the dip and it end badly for them
  15. S

    Show us your late 90s DH bikes

    Here's a couple of mine from BITD My ATX 1 My ATX 1 (small) My Lobo the only bike i have ever regreted selling!! My current ride 2000 GT DHi ( nearly late nineties) I will try to find the photos ofsome of my others and scan them in later
Back
Top