1980 Carlton Super Course
- Thread starter ianeire
- Start date
Re: 1981 Carlton Super Course
Dropped into the LBS today to remove the cranks and headset bits and yes, the fork is bent unfortunately. Not by much mind, but still.
It's hard to get an accurate measurement with a tape measure on the steerer tube. @spokesmann, would you know if these are 1" or 1 1/8" as standard?
Dropped into the LBS today to remove the cranks and headset bits and yes, the fork is bent unfortunately. Not by much mind, but still.
It's hard to get an accurate measurement with a tape measure on the steerer tube. @spokesmann, would you know if these are 1" or 1 1/8" as standard?
Re: 1981 Carlton Super Course
1" as Shaun says, pretty standard stuff these machines.
1" as Shaun says, pretty standard stuff these machines.
Similar threads
Latest posts
-
1960s 'Martyn Young' 531 build (properly finished page 5)
- Latest: Guinessisgoodforyou
-
-
-
-
