Im doing mine at the moment,changing from V's to hope c2 discs using the extended hope calliper.
The false drouout slides onto the calliper as you can see
Its then put in the dropout and a few washers are added then the nut
line up the dropouts roughly and tighten the nut but not fully because once the wheel is in you can adjust it slightly so the rotor sits parallel to the pads[a piece of white paper helps with this bit]
The size of rotor i can run is 165mm max,I've already got a 155mm rotor and ill set it up with that,i can go to 165mm should that fit better.
The distance 'between' the dropouts has gone from 135mm to 122mm[my measurement]
As my rear wheel hasnt arrived yet i dont know what its exact width is
The wheel coming did have this calliper attached as i got them both from the same seller,it said so in the ad
So I'm hoping it will just slip in.......#1
#1
Yeah right
Here comes 2 days of crying and laughing in a slightly deranged way
I'll keep you updated when i get the rear wheel in,ill then know the exact sizes of everything and be able to give you a report and any other help i can.
Cheers
The false drouout slides onto the calliper as you can see
Its then put in the dropout and a few washers are added then the nut
line up the dropouts roughly and tighten the nut but not fully because once the wheel is in you can adjust it slightly so the rotor sits parallel to the pads[a piece of white paper helps with this bit]
The size of rotor i can run is 165mm max,I've already got a 155mm rotor and ill set it up with that,i can go to 165mm should that fit better.
The distance 'between' the dropouts has gone from 135mm to 122mm[my measurement]
As my rear wheel hasnt arrived yet i dont know what its exact width is
The wheel coming did have this calliper attached as i got them both from the same seller,it said so in the ad
So I'm hoping it will just slip in.......#1
#1
Yeah right
Here comes 2 days of crying and laughing in a slightly deranged way I'll keep you updated when i get the rear wheel in,ill then know the exact sizes of everything and be able to give you a report and any other help i can.
Cheers
