Timoth27":2nru77as said:
You have xc4 Calipers there, depending on the caliper number they will need 145/165/185mm discs that’s why your 160 is way off. The rear is probably a No5 which on the back should be 145mm disc which is why it’s way off. You could use the adapter suggested above but you will still need a 165 disc. Not sure On The front (assume your disc is 160) as it should actually be that the disc is 5mm to small. Or they happen to be one of the non standard caliper numbers.
Sorry Tim, but wasn't the XC4 150mm/130mm and they could only be used with hope hubs. Distancing or such :?
Its an odd size so you might be lucky searching for that size given the xc4 has a poor rep, although that said I've not used them to rate them and I've heard people claim C2's are rubbish when its clear they aint a clue.
Other routes is to use an adaptor thats close to make a pattern you can increase or decrease. There are folk here with mini mills and if you can work out the details I'm sure someone wil give it a go.
Not that they're doing much at the moment anyhow
They had a 175mm which I always wondered what it went on, so it could be the front xc4 +20mm. that said I dont know, might be for some obscure fork.
Or email Hope. They cut rotors and do custom stuff like that. They'll likely already have all the old spec pre programed in