hopefully have more luck in here:
got a DMR revolver rear hub that i'm servicing.
the cone nut on one side is quite pitted making it roll a bit rough.
can i sand this back with fine grade and polishing compound - or will this affect the bearing race too much?
or is there a source to get a replacement?
pitted cone nut:
the worst bit:
the size:
plus the axle is 10mm diameter.
got a DMR revolver rear hub that i'm servicing.
the cone nut on one side is quite pitted making it roll a bit rough.
can i sand this back with fine grade and polishing compound - or will this affect the bearing race too much?
or is there a source to get a replacement?
pitted cone nut:
the worst bit:
the size:
plus the axle is 10mm diameter.
