Sorted Bullseye rear hub axle 130mm

[ajw573]

I am in need of an original 130mm rear axle for a Bullseye hub if anyone has one spare? The outside to outside measurement needs to be approx 138mm. It's for a pre 7 speed era 1988 Yeti Fro that i'll be using a 6 speed shimano freewheel on.

Happy to trade the NOS 120mm rear I have spare pictured below if thats of interest?

Thanks in advance!

Andy

 

[ajw573]

Thanks for the link. If anyone has just the axle that would be preferred as I have all the spacers etc. But this could be a good final option if not.

 

[ajw573]

Updated.

 

[boy"O"boy]

@ajw573 Did you find any bullseye axles?
Been rummaging in the parts drawers and found these.


138mm full length
124mm between dropouts (internal measurement) or.......


134mm full length
122mm between dropouts (internal measurement)

Both were removed from Bullseye hubs and replaced with 143mm axles (135mm between dropouts spacing)

Cheers.
boy"O"boy

 

[ajw573]

Good morning, thank you so much for getting in contact. Finding a 130mm rear axle has proven challenging as we all seem to have smaller 5 speed axles that we have upgraded at some point in the past!
Thankfully Dan Chambers has kindly offered to make one for me so all being well I’ll be sorted before too long.
Thanks again.
Andy