Brake cables

[WD Pro]

A length of thin gas welding rod to find the route through and then the tape method ?

Wouldnt have thought it would be a big problem

 

[gibbleking]

no no no no no.look the gibble knows best.



any one here a fan of american chopper?first you need some cottenthread balled at 1 end a little.put the cotten inside the tube holding on to the other end(duh).then using a air pressure hose blast air into the hole.this will push the thread out the hole at the other end.seen vince wire a chopper using this method....smug git mode engaged .....

 

[WD Pro]

Neat but not having a compressor at home I would have to eat a lot of beans

 

[gibbleking]

the gibble suggests ze local tescos garage if all else fails..

 

[rojo]

Thought i had been helpful for the first time on this site, then someone comes along betters me

 

[Iwasgoodonce]

Unless its a Saracen like mine which does have a guide.

 

[cchris2lou]

the gibble suggests ze local tescos garage if all else fails..

or a hoover .

 

[Tad]

Rather than blast the cotton thread through with an air line (not every one has a compressor) suck it through with a hoover, easy!


EDIT:
DAMN IT! BEATEN BY CHRIS!

 

[cchris2lou]

Rather than blast the cotton thread through with an air line (not every one has a compressor) suck it through with a hoover, easy!


EDIT:
DAMN IT! BEATEN BY CHRIS!

only by 4 hours .

 

[jawsum]

thanks for all the replies. i think. :roll:

ill try the bit of string and insulating tape method