Bontrager fork canti studs

slimjoe

Old School Grand Master
Feedback
View
Can anyone help me find a pair of Bontrager composite fork canti studs that go through the clamps & tighten up.
 
You mean the aluminum sleeve right? That are held on by regualr M5 (or M6?) bolts?

I think I have some extras or can easily make some. PM me in a few days if I forget to get back to you.
 
studs

classen":lsalgfgi said:
You mean the aluminum sleeve right? That are held on by regualr M5 (or M6?) bolts?

I think I have some extras or can easily make some. PM me in a few days if I forget to get back to you.

I will do some hunting for pictures and post up here. Thankyou too for your kind offer.
 
Like this?:
IMG_0250.jpg

IMG_0253.jpg

IMG_0252.jpg

IIRC the bolt's 1/4" UNF, rather than metric, but I can get some measurements this evening...

All the best,
 
These are the three I have. The two on the left are the best match, but they are a little different in length and are not completely flush on the ends.

I'll see what I can whip up in the shop today.

bonty_studs.jpg
 
Here are some shiny new ones.8)

Send me your address via PM and I'll pop em in the mail.
I only had 0.25" ID stock and the originals are 0.23" ID, but I don't think it will matter too much. Just make sure you snug them down well with the mounting bolts.

bonty_studs_new.jpg
 
Those are smart, Classen

Me:
IIRC the bolt's 1/4" UNF, rather than metric, but I can get some measurements this evening...
Nope...my mistake, the bolts are just M6 x 40 capheads.
It's the big ones in the fork crown that are 5/16" UNC :roll:

All the best,
 
Back
Top