Bontrager fork canti studs

[slimjoe]

Can anyone help me find a pair of Bontrager composite fork canti studs that go through the clamps & tighten up.

 

[classen]

You mean the aluminum sleeve right? That are held on by regualr M5 (or M6?) bolts?

I think I have some extras or can easily make some. PM me in a few days if I forget to get back to you.

 

[slimjoe]

studs

You mean the aluminum sleeve right? That are held on by regualr M5 (or M6?) bolts?

I think I have some extras or can easily make some. PM me in a few days if I forget to get back to you.

I will do some hunting for pictures and post up here. Thankyou too for your kind offer.

 

[danson67]

Like this?:

IIRC the bolt's 1/4" UNF, rather than metric, but I can get some measurements this evening...

All the best,

 

[classen]

These are the three I have. The two on the left are the best match, but they are a little different in length and are not completely flush on the ends.

I'll see what I can whip up in the shop today.

 

[classen]

Here are some shiny new ones.

Send me your address via PM and I'll pop em in the mail.
I only had 0.25" ID stock and the originals are 0.23" ID, but I don't think it will matter too much. Just make sure you snug them down well with the mounting bolts.

 

[danson67]

Those are smart, Classen

Me:

IIRC the bolt's 1/4" UNF, rather than metric, but I can get some measurements this evening...

Nope...my mistake, the bolts are just M6 x 40 capheads.
It's the big ones in the fork crown that are 5/16" UNC :roll:

All the best,

 

[slimjoe]

good stuff

Amazing work on here again. There are some seriously helpfull people on here.