Recent content by DallasEvo

  1. DallasEvo

    98 GT Zaskar LE seatpost size

    Sorted it. 27.2 now fits perfectly ✋.
  2. DallasEvo

    New member. GT Zaskar Le

    Fixed. Took the 26.8 seat post out. Removed the seatclamp bolt. Got a flat screwdriver and simply slipped it in the gap, and put a slight bit of a twist pressure (could barely see any movement. Grabbed the 27.2 seatpost………… went in absolutely perfectly 🥳.
  3. DallasEvo

    New member. GT Zaskar Le

    I was thinking this. My dad had it from new. So maybe he’s put a 26.8 seat post in and closed the seat stem gap up tightening it. Is there maybe a safe way to ease it back open ?.
  4. DallasEvo

    New member. GT Zaskar Le

    Been looking at the 400s. 27.2 don’t fit my Zaskar though. Think it’s 27mm
  5. DallasEvo

    98 GT Zaskar LE seatpost size

    Got my dad’s old gt Zaskar Le. The seat-post is too short for me. He had cut it down so no size on the post. I tried a 27.2 and it’s to tight. So I measured his post with a caliper, and it comes up as 26.8 🤷🏻‍♂️. No where online do they mention a Zaskar ever being that size. 2 days ago I...
  6. DallasEvo

    New member. GT Zaskar Le

    Thank you for letting me know. You do realise you’ve made him every target for my questions now 😆……… he’s going to be privately moaning at you 🤣.
  7. DallasEvo

    New member. GT Zaskar Le

    G10 by Farecla. Can use water with it. If using a mop with compound on paint go fairly slow. Have to be honest I have no idea with anodising. I would imagine anodising is a very very thin layer. Not like lacquer on cars which is quite thick (thicker than the paint).
  8. DallasEvo

    New member. GT Zaskar Le

    Seat stay is how it was. Head tube is after 1 minute of rubbing.
  9. DallasEvo

    New member. GT Zaskar Le

    It’s 3m. Hand glaze is more of a polish really. If I was using 3G then yeh, use water. I lied by the way 😆 (didn’t mean to) it’s g10 I used.
  10. DallasEvo

    New member. GT Zaskar Le

    I’ve always preferred a slightly small frame. Probably not now I’m old 🤭. Think I need 35cm post…. On eBay I go 😆
  11. DallasEvo

    New member. GT Zaskar Le

    I’m exactly 5ft 10 😊. I used to have a Zaskar le of my own as well (a 1994 model) that was a 16” as well.
  12. DallasEvo

    New member. GT Zaskar Le

    Seat post is about an inch below the top tube. Would it need to be past the triple triangle weld ?. Or is that enough.
  13. DallasEvo

    New member. GT Zaskar Le

    Oh blimey. Bet I have minimal in mine now I’ve put the seat for my hight. What size seatpost (diameter) was they ?. I will purchase a long one if mines to short.
  14. DallasEvo

    New member. GT Zaskar Le

    It’s only ever been ridden on road. He was never an off roader. He would have had a road bike. But he had a bad back so stuck to mountain bikes. I’ve just had a good look though 👍🏻.
Back
Top