baj
Senior Retro Guru
I’ve got an old USE seat post and on fitting a (charge spoon) saddle I find the centre area of the rear top clamp bar hits the back edge of the cup before it’s clamped the saddle rails down.. It’s like the shaft that goes through the post is a couple of mm too short?!
I’ve had these posts before and never had any issue, I’m almost certainly doing something wrong, it’s been a long night so probably just tired eyes but any help would be greatly appreciated!
Thank you in advance
I’ve had these posts before and never had any issue, I’m almost certainly doing something wrong, it’s been a long night so probably just tired eyes but any help would be greatly appreciated!
Thank you in advance