Was the once upon a time of fitting cogs to mtb's, so must go in this section.
Righto.
Building a rear hub off one of my Hope oddities, which seems to be a tandem type with disc mount, but not the usual screw on drag brake affair or direct bolt, but a 5 bolt rotor/spider interface as seen on their other mtb hubs. I think its actually a one off.
I've fitted it on a 135mm axle and its pictured set up on a C2 and mono rotor, just for the pic. But its the spacing between the screw on bit and the frame that im a bit unsure of, not having a freewheel or single speed freewheel to check it.
The spacing is approximately correct, but I reckoned someone here would know if its roughly right.
I can take other more reasonably precise measurements if needed.
Righto.
Building a rear hub off one of my Hope oddities, which seems to be a tandem type with disc mount, but not the usual screw on drag brake affair or direct bolt, but a 5 bolt rotor/spider interface as seen on their other mtb hubs. I think its actually a one off.
I've fitted it on a 135mm axle and its pictured set up on a C2 and mono rotor, just for the pic. But its the spacing between the screw on bit and the frame that im a bit unsure of, not having a freewheel or single speed freewheel to check it.
The spacing is approximately correct, but I reckoned someone here would know if its roughly right.
I can take other more reasonably precise measurements if needed.