Trying to fit some hope monos I've picked up fairly cheap but cant get them to fit. First bought a post to is mount, then found it was 69mm instead of 74. now got it on and the rotor should now be 200, the 203 I've put in is way off! edge of the rotor is about half way into the pads! going nuts......any suggestions?
Manitou x-vert + Hope mono ....pleeeeeeeease help!
- Thread starter midasdj
- Start date
gibbleking
Old School Grand Master
cut down the post mounts...ive done this too mine with no probs.....make sure the cut is flat and angled properly..you dont need to cut too much down...
