XTR Cranks

[letmetalktomark]

Hi Folks,

Another item to clear out....

1 x set of XTR M950 crank arms, beed blasted
1 x 5 arm spider for the above (two ring compatible only - ground off granny fitting)
1 x set of self extracting bolts and caps

Like these but without paint

No rings but standard ATB 110/74 spacing rather than awkward 112 spacing :twisted:

Excellent basis for uber light crank set up in the colour if your choice

£32.50 posted (Paypal Gift)

Cheers for looking

Mark

 

[Emoco]

Dibs on these.

 

[Emoco]

Oh, just realised they've got no paint. Could you post a pic of them?

 

[letmetalktomark]

Oh, just realised they've got no paint. Could you post a pic of them?

Shamelessly stolen....

The finish is slightly rough to the touch.....just begging for some white paint

 

[Emoco]

I'll leave them then. I'd be interest in the spider however.

 

[letmetalktomark]

I'll leave them then. I'd be interest in the spider however.

Spider goes with cranks I'm afraid.....

 

[iperattivo]

hi from nino

hi, 170...175 ?

 

[FluffyChicken]

Don't happen to have the bottom bracket as well ?


Just waiting to be polished up

 

[bduc61]

interest in these but do you have the BB for it ? in 68?
its not square taper right ? or is it ? was the first format of 950 ?

 

[letmetalktomark]

Hi Folks,

I do have an XTR M952 BB for these. Can be run at either 68 or 73mm but would need spacers for the 68mm setting.

Its used but not by me.

Would do a deal on the lot for £50 posted within the UK.

Cheers, Mark

Oh and they are 175mm

Could also be tempted by a swap too......tempt me