WTD Hope O2/C2 185mm Disc Rotor

Re: Re:

EarlofBarnet":1tdzv5wx said:
Thanks for the replies. It’s for a Goldtec Draco six bolt hub that I’m using on my Sintesi Bazooka. I’m running Hope C2 brakes so thought a matching rotor would be fitting. The rotor in the picture came up when I was searching.

I eyed up an Avid 180mm rotor and it looked about right. I couldn’t mount it though as it wouldn’t fit on to the hub. The six holes looked to line up but the hub seemed a tad too fat to let the disc sit on to the facing.

There is an adaptor for the hub to fit hope 5 bolt rotors. I have one here.
I actually needed one but hadnt a clue what they looked like and did see one on ebay relisted 1/2 a dozen times and id no idea that thing was the part i really needed :lol: By the time i found out via a goldtec advertising blurb the bloody thing had sold.
Thankfully another cropped up a few months later and I grabbed it.

Alternatively, should you wish and it causes next to no damage and nothing thats going to cause a problem.
The 6 bolt will fit, but the pattern is slightly different, in that i think goldtec rotors have a circular hole, and hope have the wavy flower shaped one.
You can grind off a little of those points on the hope 6 bolt and also grind away a little next to the hub disc mount hole.

You can see when you offer the two up together those little shaped bits are all thats stopping it from going on.

I should be able too get you a pic of the adaptations I made and even then after i ground them away I think just grinding on the rotor should be adequate to allow fitting.
 
Re:

Thank you for the reply, that’s some really helpful information. Wonder why Goldtec went with a slightly bigger diameter between the disc holes? It’d be great to see the adapter if you wouldn’t might sharing a picture.
 
Re:

Sorted! Tried another wheel on my bike with a 5 bolt 185mm rotor and it lines up nicely with the caliper. So it’s a 185mm I need...but in a six bolt :)
 
Back
Top