WTD: Down Tube shifter "Spacer" -the FLAT kind (al

[Dave_Mars]

I'm looking for ONE "Lever boss cover - for light alloy frames"

What a PITA to find!

It's the spacer that goes between the frame and a DT shifter ...


Picture Here ...

http://www.cyclebasket.com/products.php ... 317&z=3852

The picture below shows the one I don't want - the curved one for thin diameter steel downtubes

!

Need a flat one ASAP .. :!:

Anyone got one kicking around???

Thank you!

 

[omegastrada]

Until I found a decent set that came with a nos pair of levers, I just ground the raised parts down with a dremel. It's quite soft metal and easy to do if you're reasonably careful. Worked absolutely fine and I was using 7402 levers like those in your pic.

There was a similar request a while back on here and someone put a link to Madison who carry most of the spares - give them a try. If you have any luck, buy a few pairs!

 

[cce]

try petra cycles

 

[Dave_Mars]

Hi guys, thanks for replies.

Madison list it as a spare but don't carry it .. would be a 3 week wait :roll:

I don't trust the online vendors to actually have things in stock! But I'll check petra - cheers!

 

[GordonB]

Email me your address and I'll send you one. I actually have two and a half pairs of these as I used a single one to fit my single dt shifter to a Jagwire bar end mount adapter on my vintage tt bike. The other one is therefore going spare.

If you're quick it'll go in this afternoons post.

Gordon
email gordon at 10db.co.uk

 

[Dave_Mars]

BIG Thank you to Gorgon.


The man has sorted me out - and fer nowt ! A True Gent.