Proflex 856- needing info

[orange71]

how about swapping the rear swingarm for carbon? It's a direct swap.

 

[cherrybomb]

Gotta find one first.

 

[orange71]

I've got a spare alloy one, stripped just like yours...

that's no use to you though :roll:

 

[cherrybomb]

Not unless I build a trike!

 

[Dr S]

A bit of a shame to have got so far- go on get it finished

A bit of progress on mine today. This is turning out to be a super fast build, from unloved doorstop to this in less than 24 hours

Finished the polishing at lunchtime and started putting it together. Back end now ready to go, just need some forks and a seat post and its action stations.

Now then- seeing as the bolts in the swing arm are a little scruffy- Does anywhere sell a Ti bolt set for it??

Oh and does anyone have a Fork for it?? There is a few pairs of Noleens in the States but i'm kinda put off buying over there now after the Funk fiasco.

Si

 

[orange71]

check out this bling 856 - slightly modified with faux-bar by 'Simon' on the Proflex forum. If you need any advice re bolts etc he's your man. ( http://idriders.com/proflex/smf/index.php )

 

[Dr S]

Interesting- did he mod the rear end himself? does it work?

 

[orange71]

yes and yes and it's for sale too (think he was asking quite a lot for it though)...

 

[orange71]

Some Vectors and loads of spare parts here (scroll down once you've clicked on the link):

http://idriders.com/proflex/smf/index.p ... ;topicseen

 

[Pickle]

check out this bling 856 - slightly modified with faux-bar by 'Simon' on the Proflex forum. If you need any advice re bolts etc he's your man. ( http://idriders.com/proflex/smf/index.php )

That is a tasteful new and old school mix.....I like