Paul Brodie - Building the Whippet Part VIII - Bottom Bracket

brodie-bb-10-300x195.jpg
Following on from his previous articles Paul Brodie kindly sent us a further article detailing the rebuild of the 1888 Whippet at Flashback Fabrications. Enjoy :D

The Whippet bottom bracket is not so simple. It holds the lower spring mount, and also incorporates the swing arm pivot. On the far right is the "spoon" brake, used against the rear tire. The Whippet has no front brake. Good Luck if you're going downhill in the rain...

brodie-bb-1.jpg


More metal: 2 chunks of steel, a thick walled tube, and a couple of sealed bearings. I decided it would be easier to make a 3 piece BB, rather than carve it from solid >

brodie-bb-2.jpg


This setup is on the milling machine. The vise holds the blocks and the digital readout (not shown) makes it easier to locate centers for the bearings and swingarm pivot >

brodie-bb-3.jpg


After visiting the bandsaw, the BB was profiled on the rotary table, and filed and sanded smooth >

brodie-bb-4.jpg


Start of the spring mount. I roughed out a shape on the lathe, and then cut the sides on the bandsaw. I didn't have a drawing, just an idea of the approximate size..

brodie-bb-5.jpg


Seemed to work out OK. Sometimes I just grab a piece of metal and start making something: I don't always know the final shape, but it evolves as part of the process >

brodie-bb-6.jpg


The BB got an internal seat tube lug TIG welded on. This way, when the seat tube is brazed on, there is no warpage to the BB shell >

brodie-bb-7.jpg


The spring boss was machined from 4140 steel: quite a high carbon content so not the best for TIG welding, perhaps. It was easy to braze it on with nickel silver >

brodie-bb-8.jpg


The next step is a lathe job. We need a "spigot".. A tube is machined so the BB can be "lightly tapped" on, and the ends machined. This makes the ends parallel with each other >

brodie-bb-9.jpg


This is where it all comes together. A few very small TIG tacks will hold the 3 piece BB assembly for brazing with the nickel silver rod >

brodie-bb-10.jpg


Right after brazing. Obviously, still very hot. It's sitting on a heat brick; best just to let it cool slowly. Never quench it in water >

brodie-bb-11.jpg


Back in the lathe to bore the holes for the bearings. In Machinist talk, "size on size" would be good here. This means, using a micrometer and a telescoping gauge to measure, the ID of the BB would be EXACTLY the same size as the bearing. This would result in a "light press fit", meaning the bearing could be tapped out without too much trouble >

brodie-bb-12.jpg


That's it for now. You can see the swingarm as it fits in. The shaft is 7/16" diameter >

brodie-bb-13.jpg


Thanks for taking a mini tour of my shop.

Paul Brodie
 
[...] on from his previous articles Paul Brodie kindly sent us a further article detailing the rebuild of the 1888 Whippet at Flashback [...]
 
Really enjoying this series, thanks for taking the time to share the process.
 
Back
Top