Received a frame today but unfortunately the rear mech hanger is bent slightly in 2 directions.
In towards the other drop out.
Towards the bottom bracket so closing up the drop out hole slightly.
Its a non replaceable hanger and is aluminum.
If it was steel I would not be so concerned, but being aluminium it worries me.
Is it likely fixable by a frame shop or decent bike shop do we think?
In towards the other drop out.
Towards the bottom bracket so closing up the drop out hole slightly.
Its a non replaceable hanger and is aluminum.
If it was steel I would not be so concerned, but being aluminium it worries me.
Is it likely fixable by a frame shop or decent bike shop do we think?


