130mm Rear Hubs. What You Using?

[PanoIgano]

Of course it's possible, road bikes have been like that for 30 years.

It's a trivial thing to make a 130mm hub from a 135. Buy a shorter axle or cut 5mm off, fit some smaller spacers (B&Q washers if nothing else comes to hand). Reassemble. It's a 20 minute job.

So no redishing the rear wheel is needed if I am to convert a 135mm to 130mm? Cause I was thinking of cutting off 5mm as well instead of going through the whole ordeal of finding a smaller axle, disassembling the hub and insterting the new axle.

Anyone has tried this approach?

 

[Thame Game]

So no redishing the rear wheel is needed if I am to convert a 135mm to 130mm? Cause I was thinking of cutting off 5mm as well instead of going through the whole ordeal of finding a smaller axle, disassembling the hub and insterting the new axle.

Anyone has tried this approach?

I should've added this ages ago- I put in a Shimano 8 speed Ultegra into the Roberts. I did 'cold' set the rear drops by pushing them in a couple of mm using threaded bar and big washeres, but to be honest it wasn't really necessary to do that. The q/r on the hubs were easily up to the job of keeping the rear end tight.
You can find my thread for the build somewhere under 91' Roberts build finished. (Sorry I haven't sussed how to do a link).