Recent content by boxxer

How’s the shift action on the DX Levers / sti?

I was googling this last week as I have some to build too, I also have a built set (20mm / QR rear) so will be double checking against those as well but I think the numbers in here are close…

Would you sell the rims separate to the hubs on these wheels? At least the 3 D521’s

It’s a Hope #2 155 disk for a short axle hub. The rear hub is a short 110 and the caliper takes up the remaining space. Hope did this with most of their hubs, Ti Glide, Bulb and Big Un I have somewhere a Ti Glide rear and a set of Bulbs (might sell these to be fair I’ve had them for years...

Is it 1” or 1 1/8” size please?

Love Paul Brodie’s style, he’s just a proper engineer, chapeau on the amazing build and getting a true master craftsman on board!

It was available as a tech shop frame and a bike in late 92 as I bought my Shogun Trail Breaker 2 at Christmas 92 after failing to convince my parents i needed an RTS

2 or 3 with the curved top tube end cap

Sven had a load of 97/98 decals - I think he sold them, feathers are tough to come by… there was a €250 set on Kleinzengen

More likely 93 as the Judy FSX arrived in 94/95

Lovely Hope Suspension Hub, Titanium yes but Ti Glide was the rear Hub for a casette, the Glide coming from Hyperglide to distinguish from Screw On… If only I needed another!

They never released them seperately, there were small Hope stickers but they were longer than the hubs were in circumference so it might be a repro job….

£75 postage though!

Dan Chambers, Danson67 on here is the man for Alloy Frame fixes mate

Couple of issues there, the C2 was generally 5 bolt because they were 94-98/99 ish and normally ran 155/165/185. The 205’s came in right around the switch over point on C2 and Enduro4 in 99/00/ so I suspect not many out there. I know this because I had to ditch my C2’s and switch to E4’s on my...