Race face granny bolts
- Thread starter Tc
- Start date
shinobi
Senior Retro Guru
Re: Race face granny bolts sorry double post !!
Is this any good ?
http://www.chainreactioncycles.com/Mode ... elID=40570
Is this any good ?
http://www.chainreactioncycles.com/Mode ... elID=40570
shinobi
Senior Retro Guru
Double-E F
Gold Trader
- Feedback
- View
So Tc, which ones did you order in the end, the 17.5 Alu ones? I could use a set for my Turbines as well...
Thanks!
E
Are you fella's sure about the length of these bolt's?
I needed some for a couple of set's of turbine's and after checking a set of turbine's I had with the original bolt's and spacer's the bolt's looked more like 16mm. I ordered and just recieved these:
http://www.chainreactioncycles.com/Mode ... elID=35865
Comparing them to the original's I have, they're pretty damn close if not exactly the same length of thread.
I haven't mounted them yet though...
I needed some for a couple of set's of turbine's and after checking a set of turbine's I had with the original bolt's and spacer's the bolt's looked more like 16mm. I ordered and just recieved these:
http://www.chainreactioncycles.com/Mode ... elID=35865
Comparing them to the original's I have, they're pretty damn close if not exactly the same length of thread.
I haven't mounted them yet though...
