XT rear mech, FSA Pig, straight bladed fork

[marge602]

Hi folks. Time for a small clearout. M739 XT rear mech. Nice condition, pivots slightly worn but works well. £15 posted.

FSA The Pig ball bearing headset. 1 1/8. The fork crown race isn't pictured, but will be included when I remove it from the forks. In any case, it's in a similar condition to the rest of it. £10 posted.

Straight bladed box crown 11/8 fork. Compatible with V's and discs. 218mm long threadless steerer. Includes star nut. Possibly made by by Insane, and I seem to recall it might be a trials fork. I bought it about ten years ago to use on an early Kona, cos I couldn't find a P2 at the time. Light(ish) and strong, and really nicely made. Will need a refurb to look good again, but useable straight away. £20 posted

Any questions just ask

Marge

 

[KermitGKona88]

Hi

Could I get a dibs on the fork while I ask what the A-C measurement is please ?

Cheers

Mark

 

[marge602]

Hi. Yeah, no probs. Tell me what to measure, and I'll sort it out.

Regards

Marge

 

[KermitGKona88]

Hi Marge

From the centre of the drop out to the bottom of the fork crown please should be a measurement of 390mm +

Cheers

Mark

 

[lumos2000]

also interested in the forks if Kermit hops out

 

[marge602]

Hi. The A to C is 355mm. The measurement from the centre of the dropouts to where the steerer meets the crown(ie. where the base of the fork crown headset race would sit)is 395mm. Obviously not for geometry compensated frames then, which explains why the aforementioned Kona rode so well. Hope that helps

Marge

 

[KermitGKona88]

Yes it does help thanks over to you Lumos sorry

 

[lumos2000]

sorry the AC is 355mm not 395mm??

 

[marge602]

Yep, 355mm it is.

Marge

 

[lumos2000]

darn to short for me too