Stuff and Nonsense part II - KONA!! HOPE!! etc....

[LikeClockwork]

Kona P2 jumps forks, 170mm ahead steerer, 410mm axle to crown, some scuffs, V or disc.....£25 posted

Xero black 1 1/8" stem, 80mm reach, pretty much as new condition.....£8 posted

Hope 36.4mm (Trek/Gary Fisher/Klein) seat post clamp, you would have to be careful with the allan key bolt but still very useable....£8 posted

Stuff that's gone:
What's in the mystery box...? Buy it and see! £10 posted folks....(The WOW box in pics :mrgreen: ) SOLD

Brand new Selle Italia XO, fitted once but never ridden so some light marks to rails, possibly....£10 posted SOLD

NOT the FSA headset pictured (I used it!) but a Diatech instead, good condition, the cups off a Sky Pilot, and a bag of headset bits....£10 posted Donated elsewhere

Various QR and bolt type seat post clamps....bolt through type £3 posted for both or any of the others £3 posted each OR the whole lot for £11 posted! Donated elsewhere

 

[keithb]

Re:

Could I take the £10 XO saddle please?

 

[LikeClockwork]

Re: Re:

Could I take the £10 XO saddle please?

Yep no problem, I'm off to bed now but I'll try and PM you my PP address before the end of tomorrow....

 

[toomanyframes]

Re:

I'm sure I've had one of these forbidden boxes of mystery from you in the past??
Don't make me do it again! :facepalm:

 

[LikeClockwork]

Re: Re:

I'm sure I've had one of these forbidden boxes of mystery from you in the past??
Don't make me do it again! :facepalm:

*Laughs manically* and adds yet another piece of tat to the box.... :twisted:

(Well, I will do in a bit, got a bad back and can hardly move today :roll: )

 

[jackcustard]

Re:

Are P2 forks universal?

I've got a 98 Kona Hahanna...

 

[LikeClockwork]

Re: Re:

Are P2 forks universal?

I've got a 98 Kona Hahanna...

They should be fine on that as they are 1 1/8" ahead. The only thing to watch will be whether the steerer length is long enough?

They are basically just the toughened up version of the ordinary P2, they do look pretty cool too....

 

[jackcustard]

Re:

Can you hold these until i get home to measure?

They would be perfect if they are the toughened version

 

[LikeClockwork]

Re: Re:

Can you hold these until i get home to measure?

They would be perfect if they are the toughened version

No problem buddy, consider them on hold. For what it's worth, I think the steerer on the P2's I have in my 16" Hahanna is around 170mm....there may be a spacer or two in there as well.

 

[LikeClockwork]

Re:

All gone quiet, so bump.....

And the FSA headset in pics got used, so is now replaced with a Diatech off a Saracen, the one with a bolt up type of lock ring, but still ahead 1 1/8"....