SHIMANO XTR Italian Thread UN91 107mm new BIN £13

[one-eyed_jim]

gm, how do you successfully get the Right hand cup off, which is stuck on ?

Run a kettleful of boiling water over the shell and fixed cup - that expands the cup and softens the Loctite. Then support the flange of the cup in the jaws of a vice or similar and give the axle end a brisk tap with a rubber mallet or a hammer cushioned with a block of wood. It's a two minute job, and most of that is boiling the kettle.

 

[FluffyChicken]

gm, how do you successfully get the Right hand cup off, which is stuck on ?

Run a kettleful of boiling water over the shell and fixed cup - that expands the cup and softens the Loctite. Then support the flange of the cup in the jaws of a vice or similar and give the axle end a brisk tap with a rubber mallet or a hammer cushioned with a block of wood. It's a two minute job, and most of that is boiling the kettle.

Could make a cup of coffee at the same time

 

[one-eyed_jim]

Oh and the shop on ebay had other lengths 'out back'

I bought a couple last April - cheaper then too. Good people to deal with.

http://www.retrobike.co.uk/forum/viewto ... highlight=