Mark south wales
Retro Guru
- Feedback
- View
Hiya guys, what diameter steerer 1" or 1 1/4" on a 1993 dynatech Mtrax 500 I don't have any calipers to measure the diameter of the quill stem.
Mtrax 500 what size steerer and length
- Thread starter Mark south wales
- Start date
Andy witherspanner
Raleigh Fan
1 1/8" headset, so quill stem of 25.4mm.
Mark south wales
Retro Guru
- Feedback
- View
Hiya, thanks for that
my bad i ment the length of the steerer on the fork, as its a threaded for, for a quill stem. do i measure from the lowest point of the crown or flat of the bearing race or above the bottom race to top of tube?Mark south wales
Retro Guru
- Feedback
- View
while your hear, what stem would be on my old ozark? its a bmx sa head on the quill, so i am guessing thats a 1" im looking for the slingshot style sa head stem
Do you have a fork? Or are you looking for a pair to fit? Little hard to work out what your asking.....sorry.
If its "how to measure a steerer" its from the flat seat on the fork that takes the crown race, to the top of the tread.
However, if you need to know how long a steerer you need, measure the head tube and add for the stack of the headset....
If its "how to measure a steerer" its from the flat seat on the fork that takes the crown race, to the top of the tread.
However, if you need to know how long a steerer you need, measure the head tube and add for the stack of the headset....
Mark south wales
Retro Guru
- Feedback
- View
hiya, sorry for the delay, the ozark is gone now, restored and sold, just picked up an Avanti frame set mk2, gonna swap the bits from a mk1 mirage to that.
