Manitou1(answer) 1 1/8" for spares controltech stem xt
Manitou 1 (answer) 1 1/8" for spares/repairs. The crown and steerer are fine as are the lowers, brace and canti studs etc. Elastomers are in there somewhere but are pooped and the stanchions are both rusted up (one worse than the other).
Controltech 1 1/8" quill stem looks about 135mm. Its a flakey mess but would polish up or could be repainted just fine, mechanically its sound.
XT 1 1/8" headset has a little rust on the exterior of the lower cup but should be ok to use after a bearing change, the races are still intact. Ive literally pulled these of a bike looked inside them and put them down again so would benefit from a good clean up etc.
I dont really know what these are worth together so I will take a punt at £30 or thereabouts. If i'm miles off the mark please dont shoot me at dawn with a harpoon, it was just a shot in the dark!
Manitou 1 (answer) 1 1/8" for spares/repairs. The crown and steerer are fine as are the lowers, brace and canti studs etc. Elastomers are in there somewhere but are pooped and the stanchions are both rusted up (one worse than the other).
Controltech 1 1/8" quill stem looks about 135mm. Its a flakey mess but would polish up or could be repainted just fine, mechanically its sound.
XT 1 1/8" headset has a little rust on the exterior of the lower cup but should be ok to use after a bearing change, the races are still intact. Ive literally pulled these of a bike looked inside them and put them down again so would benefit from a good clean up etc.
I dont really know what these are worth together so I will take a punt at £30 or thereabouts. If i'm miles off the mark please dont shoot me at dawn with a harpoon, it was just a shot in the dark!
You need a camera phone. Email them over from that. 
