Manitou 1, 1 1/8 threaded

[IKSMER]

Hello,

I have a stalled build :cry: and I'm desperate to get it finished. Any help on this woud be much appreciated.


I have a Manitou 1 1 1/8" threaded 153mm with 37mm of thread.
Would like to swap for 1 1/8" threaded 156mm - 158mm length.

Or WANTED 156mm - 158mm 1 1/8" threaded Manitou 1 steerer

Or can somebody point me in the direction of the guy who makes ti steerers? I saw some on ebay and think they shipped from Germany.

Cheers

 

[ti_pin_man]

http://www.ebay.de/itm/Tune-Titan-Rohr- ... 19f8f52f24

The only word of caution I have is that Manitou 1 steerers have a groove in them with a bit of wire, this holds them tighter into the crown and they are a bitch to replace once out, from my own experience. The bolts in the crown offer some security of course but this makes them press fitted. The alternative might be a nut bolt drilling through front to back through steerer and crown. Or a local machine shop. Or the combined steerer crown unit that somebody has spare.

Good luck. I went through this issue a couple of years back.

 

[IKSMER]

http://www.ebay.de/itm/Tune-Titan-Rohr- ... 19f8f52f24

I love you

 

[IKSMER]

http://www.ebay.de/itm/Tune-Titan-Rohr- ... 19f8f52f24

The only word of caution I have is that Manitou 1 steerers have a groove in them with a bit of wire, this holds them tighter into the crown and they are a bitch to replace once out, from my own experience. The bolts in the crown offer some security of course but this makes them press fitted. The alternative might be a nut bolt drilling through front to back through steerer and crown. Or a local machine shop. Or the combined steerer crown unit that somebody has spare.

Good luck. I went through this issue a couple of years back.

Ahh, do you mean the circlip below the crown?

 

[ti_pin_man]

yep.

 

[masha]

Re:

I might have the steerer you want - I can have a measure up this weekend and let you know.

PM me if still looking by Monday