Kcnc stem 31.8mm 110mm 7 degree £12 posted or swap

[retro73]

Really light weight stem and in really great condition

£12 posted gift please

Or swap a disc caliper mounting bracket, forks have rear mounts and i need side mount or if anyone could just tell me which i need to buy as they seem confusing lol

 

[Dead Rats]

what size rotor is it you need the adaptor for?

 

[retro73]

165 mm - just measured

 

[Dead Rats]

I only have 160mm rear adaptor... although 2 x 2.5mm (worth of) washers between it and caliper might work - in theory that sounds like what I'd do? Or get a proper 165mm one! Hope this helps.

Maybe post up a photo as I'm not quite sure what you mean by rear mounts on the forks - do you mean IS mounts?

 

[dirtydozen]

yeah what do you mean a rear mount?
looking at you forks from the back would the bolts go straight into the forks or across them if that makes sense

which of these does it look like
http://3.bp.blogspot.com/-Rftz1iuxTEY/T ... b_type.jpg

 

[retro73]

Second picture

 

[dirtydozen]

http://www.chainreactioncycles.com/Cate ... goryID=525

look through them, you need PM to PM 165 or 160 and use a couple of washers

 

[retro73]

Brilliant - thanks for all the help

 

[Dead Rats]

http://www.chainreactioncycles.com/Categories.aspx?CategoryID=525

look through them, you need PM to PM 165 or 160 and use a couple of washers

maybe the caliper will bolt straight on with a 160 (maybe with the washers) it does on my Manitou PM forks with no adaptor

 

[retro73]

Its going on a manitou mars fork as above