IRD Keeper for Bullseye cranks.

[Neverl8]

Re:

Excellent - let us know when you have a new batch ready to go.

On another note, anyone know where i can get the little safety key that fits on the non-drive arm pinch bolt?

 

[Rampage]

I have loads of those!

 

[Neverl8]

Re:

Sweet - package deal then

Let me know when you have the keeper sets ready to go!

 

[Rampage]

I have some more availible now.
£25 including UK postage. Anywhere else +£3 NOT TRACKED, or +£7 TRACKED
Postage will probably be next Monday as I am very busy.

 

[Rampage]

 

[Rampage]

I think I've contacted everyone who has PM's me about these, apologies if not.

 

[Neverl8]

Re:

Well this is just swell. Turns out i have a very old and very rare set of Bullseye cranks with a 3/4" spindle or 19.05 mm. :shock:

Not the typical 7/8" or 22.225 mm spindle so your keeper will not work. Do you machine the ends yourself? anyway i could get a custom keeper?

I knew these were very early first gen, just didn't know exactly how early they were. guess my bottom bracket options opened up some though.

 

[Rampage]

There seems to be a few different sizes.
I can make any size for them, just let me know an accurate inner diameter measurement, also the diameter of where the caps sit against incase there is any difference.

 

[Neverl8]

Re:

Sweet! i'll get the vernier calipers dusted off and get some precise measurements.

I remember the internal spindle diameter was 1/2" or 12.7 mm, but i will verify!

 

[Rampage]

Re:

Ok