Hub Axle identity help needed

[dyna-ti]

I got this a while ago thinking it was hope and would fit my axleless hub.
It didnt there was only a slim chance it would fit as i didnt know the exact model.
Ive since found out its not for hope hub but i still dont know what it isfor.

The sizes are 20mm diameter.100mm usual on the outside of the spacers and 75mm between them.
Anyone?

Might have something to do with marzocchi :?

 

[mikeekim89]

:?

super monster axel maybe? :?

 

[KermitGKona88]

Damn thats a big axle does it make phone calls too Nice table BTW

 

[Enid_Puceflange]

My Marz Shivers take a 20mm axel and this looks either to short or too fat for them ! :shock:

Could it have anything to do with a Qr20 axel? :?

Would a qr skewer fit down the centre?

Gc

 

[dyna-ti]

My Marz Shivers take a 20mm axel and this looks either to short or too fat for them ! :shock:

Could it have anything to do with a Qr20 axel? :?

Would a qr skewer fit down the centre?

Gc

It is for a quick release but the axle itself being 20mm must fit in a bolt through set up ,or as a spare to enable QR use :?

I'll look up the original seller and see if i can contact him to find out :?

Nice table BTW

Cheers Though ive had some problems with the 2-pack lacquer bubbling over the joints in the veneer.
and thanks to the terrorists and our jumpy government i can no longer buy the acetate to remove it,so i can refinish it :roll:

 

[orange71]

not one of those Specialized thraxle / thru axle jobbies is it? Only guessing as it looks a little like something my mate's Pitch has on its front wheel. Don't understand how all this modern stuff works...

EDIT: prob not actually :roll: