Hope m4 disk and caliper and hope 04 caaliper and spider

[Jay]

Right first off i have a hope m4 "185mm" front disk and caliper

not to much to say really it has the usual scrapes from youraverage riding, it was bled about 2 months age,

the pad conditions are good lots of life left in them but as a added bonus i will chuck in a spare set,

the disks looks in good condition and again loads of life left in it,

£40 posted ono

NOW SOLD


I also found this in the garage

I bougth this caliper over 12 years ago, its had a hard life, it was in full working order when i took it of the bike but that was over 2 years ago,

So i would suggest ethr this was used for spares or with a good servie it could be made good,

£15 posted

Cheers jay

 

[dbmtb]

O4 caliper is a bargain - will take it if it'll make up a pair with my front one.

What other number does it have engraved on it?

 

[Jay]

O4 caliper is a bargain - will take it if it'll make up a pair with my front one.

What other number does it have engraved on it?

Sorry not sure if i put it in the origina post its a front 04 caliper,

no it has no other numbers on it

 

[dbmtb]

04 means it's a DH4 4 pot caliper.

They were made with interchangeable halves dependant on what size rotor and what standard fittings you had. Each half is designated with a number - for example, a 3 half is for 185mm front or 160mm rear IS. Further down on the protruding extended part below the calipers, there should be engraved a number.

What size rotor did you run up front?

From the photo it looks like it may well be a 3.

 

[Jay]

04 means it's a DH4 4 pot caliper.

They were made with interchangeable halves dependant on what size rotor and what standard fittings you had. Each half is designated with a number - for example, a 3 half is for 185mm front or 160mm rear IS. Further down on the protruding extended part below the calipers, there should be engraved a number.

What size rotor did you run up front?

From the photo it looks like it may well be a 3.

Christ you learn somthing new every day,

I ran a 185mmm disk

 

[dyna-ti]

Yeah,thats a 3 alright
If you fit it on the rear the No3 was for a 165mm rotor,standard nowadays,and +20/+40mm adaptors are easy to come by


Excellent news for Mr Dbmtb

 

[Jay]

Yeah,thats a 3 alright
If you fit it on the rear the No3 was for a 165mm rotor,standard nowadays,and +20/+40mm adaptors are easy to come by


Excellent news for Mr Dbmtb

thanks good to knowthats what i have

cheers jay

 

[dyna-ti]

Good for the man there
God knows finding a pair of anything on here is difficult or frustration enough,you usually wait for weeks or months ,then sell it in disgust,just as the world and his cousin pops up to sell theirs :roll:

 

[Jay]

bump

 

[dbmtb]

PM sent. Will definitely take the DH4.