Forks, Chainring, Cranks, brake studs etc -price drop + more

nathanman

Retrobike Rider
I have set of Judy xc's for sale, cosmetically a little rough but nice and bouncy and all dials appear to work. Worst of the paint chips are on the brace. Steerer is 1+1/8 and is 187mm long. £30 posted - pics in the link below. No brake bosses included. SOLD

http://www.flickr.com/photos/29924174@N ... 606853022/

8mm black screw in brake studs £8 posted

Tioga steel chain ring, 22T in 74 bcd 5 bolt - light use only £7 Posted

Shimano Acera 175mm Cranks with IG rings and bolts (22,32,42 iirc) with M330 non drive arm - square taper and in decent condition. Loads of life left in these - £12 posted. Pics in link below.

No name silver stem - 120mm and about 6 degrees of rise iirc, not oversized, no major scratches and would polish up lovely £7 posted Pics in link below.

http://www.flickr.com/photos/29924174@N ... 344025365/

RST 461 forks - in need of a service and a good clean, these have sat in my garage for about 8 years doing nowt, not seized(i've hand bounced them) and stantions look good. Steerer is 1+1/8 200mm long and appears to be removable £12 posted.

Marin lite bars - Slight dent in clamping area but not noticable when clamped. Uncut with a few scratches £7 posted

Marin lite Quill Stem - 25.6mm used with minor scratches to black top cap (also some very minor rust on cap that will clean up ok) £7 posted

JD 27.2 x 330mm seat post - Matt finish in silver alloy, good condition and uncut £8 posted.

2nd class Postage is included to UK address but i will post elsewhere at cost, collection will be cheaper as no post + packing costs. Dibs followed by PM please, i will happily do a deal on multiple bits.
 
dirtydozen":3vd6ctco said:
any idea if the brake studs will fit either my marzocchi jnr t or my rst alfalfa?

I think front studs are pretty standard across the board, if you let me know the tread diameter on your forks i can measure up the studs and confirm.
 
Back
Top