This is cut and paste from Steve Garro of Coconino Cycles
' OK, so here is what you do: take some shears & cut a piece of beer can 1" x 3" out & then cut it into strips 1" x .25" and fold these in 1/2, placing them around the rim of the HT like flower petals, folding them over the edge of the HT all around. Now, start the cup to "seat" the micro shims. now give it a few drops of sleeve retainer, fully press in, cut the edges of the 'petals" off with an exacto & run it for the rest of the frame's life. - Garro.
Share
|
Like
Steve Garro, Coconino Cycles."
' OK, so here is what you do: take some shears & cut a piece of beer can 1" x 3" out & then cut it into strips 1" x .25" and fold these in 1/2, placing them around the rim of the HT like flower petals, folding them over the edge of the HT all around. Now, start the cup to "seat" the micro shims. now give it a few drops of sleeve retainer, fully press in, cut the edges of the 'petals" off with an exacto & run it for the rest of the frame's life. - Garro.
Share
|
Like
Steve Garro, Coconino Cycles."
