Crank caps

[perry]

Yeah . you just need some that are 8mm for the bottom bracket . The crank extracting thread is all the same although you can have the crank tapped to a larger size if the threads pull out but it's rare .

http://www.chainreactioncycles.com/Mode ... delID=1201

If you want alloy bolts use a steel bolt to torque the cranks up then remove the bolt and put the alloy one in its place without adding any tension to it .

 

[stevek]

Fnarr fnarr! :twisted:

There are some on CRC but the pic shows an Isis sized bolt even though the description says square taper? Send 'em an email to confirm? May take a while for a reply though, those guys are pretty busy.

 

[Lysander]

I've used Dream Cycles Online in the past for self extractors.........has a multitude of type and colours

http://stores.ebay.co.uk/DreamCycles-On ... ec0Q2em322

 

[stevek]

Yep, they're the one's I was looking at Perry, pic shows the wrong bolt?

 

[perry]

Good point Steve , I didn't pay much attention to the photo . They also have the m15 listed as a separate part so I guess they just got the photo wrong .