Chainrings, Shokpost, misc front mechs, V's, shifters

[D_XZ]

Talon chainrings from 98/99, anodised red. 22, 32, 42 teeth. Very little use - less than 3 months. They came on my middleburn cranks in but were the wrong colour. I had to accept them as I was racing that weekend! Colour taken off on the teeth by chain and little chainsuck marks on big ring - shown both sides in pics £30

X-Lite bar ends, scuff mark on surface of one at corner - tried to show on pic. £10

Deore V brake full set (no noodles) £25

XT front mech, M750 31.8 top swing top pull, never been used. From 1999 I think. £15

Deore front mech, fits 31.8 and 34.9, top swing top pull £10

Front mech circa 1999 31.8 top swing bottom pull...not sure but think it's alivio. Low end anyway. Well used but still functional £6

7 speed shifters, basic model - think they're alivio but my memory fails me. £7

Use SX shokpost, 27.0 good condition, some scuffing to logo - shown both sides in pics. (saved my back on my old zasker!!) £30


Higer res. pics can be emailed on request - I had to shrink the quality to post here!

 

[reanimation]

Is post included on these?

Interested in the shifters, defo 7spd and work good?

V brakes, are levers included?

And finally! how long is the seat post?

 

[geetee61]

What bcd are the c/rings? :?:

 

[D_XZ]

Prices include post to UK

Shifters are definitely 7 spd - just clicked through them to check. Haven't had them on a bike in several years but the mechanism works fine when clicking through. As mentioned they are a low model so not as slick as XT etc.. but yep - they work!

V-brakes include deore levers in top left of pics and pads with plenty of wear left (as seen in pics)

Seatpost is 35cm from bottom of clamp curve at the top to bottom of post. Would be 36cm from bottom to saddle rails when fitted.The "max height" marker is 113mm from bottom of post.

 

[omar71]

Chainrings are 94 or 110 ? And for 8 or 9 speed ?
thanks Roman

 

[D_XZ]

What bcd are the c/rings?

Measured according to the method in this link:
http://www.sheldonbrown.com/gloss_bo-z.html
I get 9.35cm for the large and middle ring and 5.78cm for the granny based on a bolt to bolt measurement of 55mm and 34mm respectively. Allowing for my measuring accuracy being up to 1mm off dead centre, I guess they are for a 94/58mm compact drive spider.

If there's a better way to measure let me know and i'll try it.

 

[D_XZ]

Chainrings are 94 or 110 ? And for 8 or 9 speed ?
thanks Roman

94 according to measuring method linked in my last post.

For 7/8 speed chains. I had 7 speed back when I ran them.

 

[omar71]

chainset - shipping price to czech ?

 

[D_XZ]

chainset - shipping price to czech ?

Extra £2.00 UK for standard airmail