MattiThundrrr
Kona Fan
New cable inners and straddles will go a long way. Also think about a straddle block like Tektro make. Jagwire has one too.
Last edited:
Cantilever Brake Masterclass
- Thread starter Iwasgoodonce
- Start date
The xc pros won't be the problem....its the setup angles....
Im sure lgf is going to say exactly the same as me!
Those cantilevers are good kit, far better than the later low profile jobbies.....low profile really didn't work unless you stuck half block stud through them to widen them back up again!
Im sure lgf is going to say exactly the same as me!
Those cantilevers are good kit, far better than the later low profile jobbies.....low profile really didn't work unless you stuck half block stud through them to widen them back up again!
First, are the springs in the same fork hole position on both forks?
Second, are the springs inside in the slr postion or normal postion on both?.....im assuming they are m732?
Third push the blocks out a bit and angle them to the rim when applied.....(if put out of line that's how your tyre went bang).
Then its straddles and balancing them up....
Second, are the springs inside in the slr postion or normal postion on both?.....im assuming they are m732?
Third push the blocks out a bit and angle them to the rim when applied.....(if put out of line that's how your tyre went bang).
Then its straddles and balancing them up....
Similar threads
