Bullseye cranks

[pete_mcc]

I am a sucker for bullseye, in my collection I have 110, 130 and rare 94bcd spiders, a spare pace spider, 1st gen and third gen cranks (7 sets), a few bearings, a load of bolts, a couple of home-made keepers and an ird one and a few Durham rings. I also have a load of original literature including a letter from Roger Durham explaining why his bearings are duff in the UK!

I could send you details of my keeper but you may have to amend slightly as the ID of the axles does vary as do the axle lengths - that one was designed for the longer Pace axle. I will try and take my ird one off and see if I can take some photos of that also

If he does need a physical one I am sure I can help

 

[xxnick1975]

Re:

you are a top man, thanks for your helps, these cranks have been an enigma for me for so long, maybe now i can get them in use

 

[pete_mcc]

Re:

Bullseyes using hope 24mm BB and shim:

Bullseyes that have been shaved to 22mm using BMX Euro BB:

 

[MatBH5]

Re:

Hello, a very useful thread. I too could do with a keeper.
For manufacture like this, I'm never sure whether it makes much difference to produce multiples, but if Rampage is happy to make two, I'd be interested.
Cheers,
Mat

 

[xxnick1975]

Pete, that's so good of you.

Thanks so much for taking the time and trouble to do that for me.

I have pm'd Chris with a link to this thread so lets see what he says, but with those diagrams should be good i would have thought

many many thanks - very helpful

and Gil has shims too so its all coming together!!

 

[xxnick1975]

i have mentioned to him that its quite likely a few would be interested, so lets see

 

[pete_mcc]

A few more photos (I'm off work today, can you tell?):

A range of spiders:

My modern seven titanium with a set on a 94bcd spider:

 

[xxnick1975]

Re:

Wow, you certainly now your Bullseye, make Jim Bowen look like an amateur

 

[xxnick1975]

for anyone following this thread - Rampage is on the case and will try and make a few keepers, so if anyone wants one, worth PMing him so he can gauge demand

again thanks to Pete and now to Chris

 

[Rampage]

Re:

Thanks for the measurements Pete.
Is that on original Bullseye?
I had one here and it was different, two caps with bolts that threaded into a long internally threaded cylinder.
What are the two holes for on the longer one?