Wanted Broken/Damaged SRAM 10s Force/Red Rear Derailleurs Wanted

[jahknob]

I'm looking for SRAM Red/Force 10s rear derailleurs that may be cosmetically poor or crashed, to try to get some spare parts that aren't available any other way. If you have one unwanted in the spares box, please get in touch.

Thanks for looking.

 

[zerogravitas]

Hi, what parts do you need from them? I have some of a Force 10 derailleur in my bits box but I have taken out the pivot pin and retaining screw for a Red 10 derailleur.

 

[jahknob]

Looking for the main pivot spring and the outer cage plate (the one with the pin that the spring sits around), plus the plastic bits off the SRAM Red that the high/low adjusters screw into..

 

[zerogravitas]

Okay, will dig it out in the next couple of days and show you a few pictures.

 

[zerogravitas]

Here are the Force bits I have. Any use?

 

[jahknob]

Hi,
I can use the spring, I think. Where is the pin that should be attached to the cage plate in the foreground? It's like a little tower sticking up from the large hole almost dead centre near bottom of picture and it's just gone - did it break off? Is the derailleur stuck on the dropout? All the other bolts have gone/been re-used?
If you can pop the spring in an envelope and post to me, would a fiver do it? If so, send me an email address to PayPal F&F and I'll sort it.
Best,
Neil

 

[zerogravitas]

Hi,
I can use the spring, I think. Where is the pin that should be attached to the cage plate in the foreground? It's like a little tower sticking up from the large hole almost dead centre near bottom of picture and it's just gone - did it break off? Is the derailleur stuck on the dropout? All the other bolts have gone/been re-used?
If you can pop the spring in an envelope and post to me, would a fiver do it? If so, send me an email address to PayPal F&F and I'll sort it.
Best,
Neil

Hi Neil, I pressed out the pin you are talking about and replaced the worn titanium pin in my 10s Red derailleur with it! It's a known fault that the ti pivot pins on 10s Red wear out and can fail catastrophicly; this Force derailleur I actually bought on eBay for just that part, and the retaining screw.
The derailleur came stuck to the dropout and with some other bits missing as you see, but it had the pin I needed. Sorry I don't have more bits for you!
You can absolutely have the spring though, will PM my details.