Bits for sale

[bikie]

4 Wing nuts £8 inc postage
New and unused 40 tooth Specialities Chainring £20 inc postage - SOLD
Baylis Wiley Size14 bottom bracket and cups £8 inc postage
Rear rack £8 inc postage - SOLD

 

[Blacktopdisciple]

Re:

Hello

Id like to buy the TA chairing please, if it is still available. I can pay by paypal.

Thanks

Trevor

 

[half cog]

Re:

Hi
What size thread are the wingnuts please?
Regards
Peter

 

[bikie]

Re: Bits for sale- wing nuts

Not sure on thread size but they fit standard wheel axle.

 

[half cog]

Re:

Hi.
Sorry I should have been more specific. I am looking for some for 5/16 axles as found on older hubs. I have a pair like the ones on the left but the chrome is not good. The cyclo copies on the right would be perfect for the build I am doing. If these fit modern hubs ( shimano e.t.c.) then they wont fit.If you had tried them on something like an old mailard then they might.The older axles are quite a bit thinner. Will have them please if they are for 5/16
Regards
Peter

 

[jm]

Re:

5/16” is the really thin looking front.
3/8” is the wider rear.
9mm modern front.
10mm modern rear.
That’s a basic guide.

 

[half cog]

Re:

Thanks for that JM.Im gathering bits for a 1937/8 Baines ecolite build. Made in Bradford just before the war it was their fixed wheel model. Baines is famous for the flying gate now made by Trevor Jarvis and I got some copies of the original decals from him. The vcc library has a photocopy of a 1936 catalogue so I have a fairly good idea of the original spec ( mostly whatever you want )I am not rushing to finish this. More of a background project but I did build it up with modern stuff (1960/70 ) to try it and it rides well.Have now stripped it to start the build properly.If the cyclo copies were 5/16 they would do nicely. The gripfast ones would look a bit too modern. Thanks again for clarification
Regards
Peter

 

[bikie]

BUMP

 

[bikie]

Bump

 

[jm]

Re:

How much pitting is on the axle and cups please.