3 XTR front mechs, 2 NOS, 1 mint, carbon - 1 LEFT

[paddlingpool]

bumpy

 

[paddlingpool]

these have to go! dont be afraid to make me an offer. all offers will be considered.

 

[paddlingpool]

Monday bump

 

[Xesh]

........However one thing I though about is the width of the front mech mounting bracket itself. It measures 2.5mm which means that your left hand crank arm would be 2.5mm closer to the chainstay.
I guess that this would not be a problem if your axle is of a sufficient length.

These mechs will fit any Shimano E-type BB. The hole in the bracket is for a bolt that screws into the frame to stop the mech moving in the event that the BB comes loose. I believe that you can buy a clamp on mount for them, but I can't remember who made them.

As far as the crank clearance goes this isn't an issue if you use an E-type BB as the axle is offset to allow for the mech mounting plate. If you use an E-type BB without a mech of this type then you'd have to fit a spacer on the driveside, otherwise your chainline would be wrong.

If I had the money I'd have the 960 mech off you, but I don't, so I can't. :cry:

 

[paddlingpool]

Reduced Again...

 

[paddlingpool]

Final Reductions. Come peeps grab a bargain!

 

[paddlingpool]

BTTT

 

[paddlingpool]

Update:- NOS FD-M950, Top Pull, Carbon bracket, - £35 -SOLD

 

[paddlingpool]

2 left...

 

[paddlingpool]

bumpy...