Headset Play
- Thread starter Mr Weirdo
- Start date
Crown race looks ok to me. It's the top lock nut part that doesn't look right. The top lock nut should be sitting pretty much flush with the top bearing race cup assuming that the steerer has that notch in it to take the lock washer that fits between the two.
The metal cups have a plastic cover moulded on top so what looks like a crack is just the joint in the plastic moulding. The joint is through the "o" in Shimano, hopefully which you can see in the photo attached.
The metal cups have a plastic cover moulded on top so what looks like a crack is just the joint in the plastic moulding. The joint is through the "o" in Shimano, hopefully which you can see in the photo attached.
Attachments
Bugger...
- Feedback
- View
on these headsets, the washer/ spacer between the locknut and the headset is recessed into top of the headset which is often forgotten
I think I have a complete Sport LX headset if needed
I think I have a complete Sport LX headset if needed
That's very kind of you. Fortunately I do have a couple of headsets which I believe are complete though after this event I will double check. Thank you again!
- Feedback
- View
You didnt think I was just going to give it to you??
There would have been at least one cider involved...
There would have been at least one cider involved...
Can I then tempt you with a pint of alcohol free cider? It's all the rage
