Show us your…. Shiny parts
- Thread starter Mod-Master
- Start date
MuchAlohaNui
Senior Retro Guru
Polishing is another thing I would like to learn to do proper. What is your tooling, pads and compounds setup comprised of? Or did you do all of that by hand?
KayOs
Dyna-Tech Fan
I sand by hand with 800 to 1200 grit. Then I bought a polishing set for the drill at the DIY store. It comes with a rag wheel and blue and white polishing paste. I have a pillar drill, so it works quite well. Finally, I use polish and go over everything again by hand. Until it's enough for me. I use "Elsterglanz" aluminium polish. I know it from my childhood and was always satisfied with it. So it's not a professional material.
MuchAlohaNui
Senior Retro Guru
Awesome. Thank you. You're in Germany? What else are you going to polish?
KayOs
Dyna-Tech Fan
Yes I'm from Germany.
I have a couple of headbadges lying here that I need to finish and polish, then a couple of cranks and the topcap of the cattlehead could do with a saying and also polished.
MuchAlohaNui
Senior Retro Guru
Howdy. In the middle of re-anodizing these old SRP 'The Brakes' 2.0 cantilever brakes. Been a fight and a half with etching, anodizing and dying. I have about 20 hours into these with all the redoing and troubleshooting 
MuchAlohaNui
Senior Retro Guru
Bumperino? Nothing shiny since the end of June? Or did some stuff get lost in the site hack?
Anywho, for the (never ending) Serotta ATi build like the brakes above.
Action Tec titanium chain rings DIY anodized purple, teal & green.
Anywho, for the (never ending) Serotta ATi build like the brakes above.
Action Tec titanium chain rings DIY anodized purple, teal & green.
27motorhead
Senior Retro Guru
- Feedback
- View
His build thread is awesome and the home anodising experimentation is amazing with lots of detail.
1994 Serotta Colorado ATi - and a Lot of DIY Anodizing
Aloha Kakou and welcome! A new year and a new project. I was organizing parts and bins this morning and realized I have most of the the items on-hand to start this project. The bulk of the items are here and some will swap out as this build progresses. I accidentally bought a 1" Titec Titanium...
www.retrobike.co.uk
MuchAlohaNui
Senior Retro Guru
I'm taking that.
It's detailed so I can go back and check my notesHis build thread is awesome and the home anodising experimentation is amazing with lots of detail.
Oh and it's quite a nice frame I guess.1994 Serotta Colorado ATi - and a Lot of DIY Anodizing
Aloha Kakou and welcome! A new year and a new project. I was organizing parts and bins this morning and realized I have most of the the items on-hand to start this project. The bulk of the items are here and some will swap out as this build progresses. I accidentally bought a 1" Titec Titanium...
. Thanks for the plug!
