thom04's latest activity
-
A teeny tiny tiny wincy bit overpriced By £89 -
Nipped out on the TiBride to find an enormous tree, but unfortunately the tree was in the middle of freshly sprouting crop and covered...
-
@thom04 best rough advice I got (as fit is obviously tailored to the person) was to make sure saddle height and fore/aft are set...
-
thom04 replied to the thread Today's Ride.Managed to get out in the lanes again today in the sun before the rain hits next week 🌞😎 Was a bit stop start as I'm tweaking some new...
-
-
thom04 replied to the thread Seat post angle shim? 🤔.Yeah I think it might be 😂 I'm going to try and file a bit of material off the head first & see where that gets me - I only want a...
-
Had a very near miss yesterday thanks to a moron of a driver speeding and overtaking another car on a blind corner, veering into the...
-
Took a bikepacking trip to Malham cove. Pottered up the leeds liverpool canal, camped at a site in malham and then back via Settle...
-
Got up this morning.. Leonard had made a new friend ..made some coffee Rode up to Burbage ..stopped for a drink.. I wore these...
-
-
enjoy the warming sun 🌞
-
thom04 replied to the thread Seat post angle shim? 🤔.It is very flat - it does match the clamp properly when the shim isn't there though. I did try it the other way round ages ago when I...
-
thom04 replied to the thread Seat post angle shim? 🤔.Image one - red arrow showing small alu bodge to get a couple extra degrees tilt on the saddle ( bringing it down flat) Image two - not...
-
-
thom04 replied to the thread Seat post angle shim? 🤔.good idea 👍🏻 I don't think there's loads of material back there, but I can't imagine a couple of mm will hurt. Got me thinking that...
-
thom04 replied to the thread Seat post angle shim? 🤔.No worries, I'll grab a photo later when I venture out to the shed 👍🏻
-
