Recent content by Grimaldinho

Rear mech received. thanks

I'm interested in the rear mech. PM on way..

Seat clamp size? Hi Folks, Just picking up on my 'summer' project after a busy couple of months. I've just had my Ballistic Tange Prestige frame back from the powdercoaters and was wondering if you know the seatclamp size? I guessed 28.6, but the one I've tried would be a bit tight at...

Thanks for the quick response folks. Yes, it seems that a 26.6 has been run in it for a wee while (Kona Fire Mountain 94 post?). :D

Seat tube diameter Hi, I know this is an old thread, but I own one of these ballistic frames (19") and it seems that the wrong size seatpost had been used in it. Do you know what size post it should take? Thanks.

Hi folks, I'm after a middle ring for a shimano compact drive lx chainset circa 95. BCD 94, either 32 or 34 teeth. Anyone have one kicking around?

Interested in the forks here.

Thanks for the feedback folks. I'm hoping the frame is a bit more of a goer to restore than the forks. It has a fair bit of rust around the bottom bracket/rear stays. I had a look inside the tubes where I could when taking it apart and it seemed pretty sound, but my concern would be the rear...

Cheers Matthew. Yes, I did think that might be one solution! This idea to 'spruce up' my old bike is looking more expensive every minute!

Hi Folks, First time poster. I'm in the process of trying to restore my mid 90's bike as commuter bike. No doubt I'm going to be putting on a few more posts over the course of the summer! I stripped the bike down over the weekend (with the exception of the bottom bracket - that's another...