Today I stripped the bike down to the bare frame ready for its powder coating. Well that is untill I tried to remove the Bottom Bracket, the axel has hexaganol ends instead of square taper with the non drive side needing a 32mm spanner. Do I need a special tool to remove the bearings?
Before removing everything I "fixed" the U brakes which are twinned with some V brake levers, despite my best efforts they were pretty rubbish at stopping me. Should I be fitting canti levers could someone tell me please?
Any advice would be greatly appreciated and thanks in advance.
Before removing everything I "fixed" the U brakes which are twinned with some V brake levers, despite my best efforts they were pretty rubbish at stopping me. Should I be fitting canti levers could someone tell me please?
Any advice would be greatly appreciated and thanks in advance.