Road quill stem 22.0 diameter ( not 22.2!) 90 or 100 mm

bduc61

Senior Retro Guru
Feedback
View
Hi

looking for a "french" quill stem with a 22.0 mm diameter ( so not a 22.2mm which is much more common :roll: )

possibly between 90 or 100 mm length

and for a 25.4 bar

thanks
 
I found a pic of it,will get a length tomorrow.jm.

8238251274_342ea16d9e_c.jpg
 
jm":2055jmer said:
I found a pic of it,will get a length tomorrow.jm.

8238251274_342ea16d9e_c.jpg

can you confirm the diameter for the bar ? as the gap for the bolt looks to have been "increased" to accomodate a bigger bar than it was meant for ? or is it an optical "impression"

keen to see the nitto too ;)

thanks to both for the trouble ;)
 
I have an Atax that I dug out of the bin for you today. It's in the Cinelli XA style. It was in the bin because it has a rounded bolt so that would need sorting out, other than that it's alright.....
 
Blacktopdisciple":1jgo5erw said:
Hi here is the Nitto;

http://www.flickr.com/photos/16704837@N08/9409566354/

http://www.flickr.com/photos/16704837@N08/9409565786/

I have not cleaned it so it has dried greese on it. It has some scoring where it has been inserted into the steerer. It is a 22mm stem. The bar clamp is 25.4 mm. It is 100mm long. It is marked Pearl 9 Nitto Forged. It came off a late 70's Gitane.

Hope this is what youre looking for. Im thinking if you want it I would sell for £27.50 posted.

many thanks for the trouible but for the moment, I ll pass on the nitto as was looking for something a bit lower in budget and possibly without side engraving


Tel":1jgo5erw said:
I have an Atax that I dug out of the bin for you today. It's in the Cinelli XA style. It was in the bin because it has a rounded bolt so that would need sorting out, other than that it's alright.....


any pic ?
 
Back
Top