Replacement MCUs or solid elastomers for old skool forks

[johndeverill]

Some of you might have been following what I'm up to. Right I think we're ready to go! These
are Mk1 Pace RC35 MCUs. Red are hard, yellow are medium and orange are top out bumpers. 10mm top out gives approx 50mm travel with medium MCUs. Full set will be £27.50 or mix (I.E full set of medium + 4 hard or vice-versa) will be £35. To mix and match the originals like that would be £80-90 new! Can also supply a 50g tub of nice slippy silicone/PTFE grease for £6. I can also make 25mm, 22mm, 21mm, 19mm or 16mm diameter versions for other forks with 10mm, 6mm or 5mm ID holes. Can also be solid elastomers rather than MCU. Service of forks and installation an option too. These are made to order and will take approx. 10 days for delivery as the rubber takes 7 days to mature....like a good wine or whiskey! PM for more info.

 

[mk one]

will look to get some when i get around to rebuilding my pace forks.

Will also definatly have a couple of sets for my Judy's.

 

[johndeverill]

Re:

Hi, no probs. Do you have any measurements for the judy ones? Cheers

 

[rwm1962]

Nice one. Bookmarked.

 

[mk one]

Re: Re:

Hi, no probs. Do you have any measurements for the judy ones? Cheers

Ah, no, measuring mush is a bit tricky

 

[johndeverill]

Re:

No probs, I'll look into it!

 

[johndeverill]

Re:

MKone....which Judys are they? Cheers

 

[johndeverill]

Re:

.

 

[johndeverill]

Re:

Currently working on a Manitou 3 set too

 

[slackboy]

Re:

I've got some Judy's that aren't mush. Will try and measure them later